[SeanGTS]

Hey guys, I'm doing some work on the girls car. Its a 95 Camry, Automatic 4 cylinder with no ABS.

So far, I've put a new valve cover gasket on, full tune up, starter, and now I'm trying to install the new driver's side axel.

The drivers side axel was a pain on my celica, but its being just a bitch on this camry. I've compared both axels (old and new) and I'm positve they're identical! Though, this damn axel wont go in! Any tricks you guys know of? I'm a little scared to just "pound" it in, I actually ruined my celica transmission by doing that. Their's bearings in there that receive the axle, and I'd hate to destroy them.

I've heard to point the C clip down, I've also greased it up to no avail

Sean

 

[SeanGTS]

Nevermind, got it.

 

[zoni]

it just takes some finesse, im sure you figured that out...

i hope you replaced the axle seal while you did the axle... its only a few bucks, and can be a bitch to do on its own.

 

[SeanGTS]

Bah, no leakage, works like a charm.

You've just gotta be gentle with it

Besides, with air tools, that axle can be out in 10 minutes

 

[zoni]

just wanted to add the info for people who will eventually do it... you should always replace the seals whenever you hve them out.