Toyota Nation Forum banner
1 - 1 of 1 Posts

Discussion Starter · #1 ·
Say does any one know how to read the engine codes?? My Haynes manual
covers all except the 1996 4 cylinder with OBDII !! The jumper from
TE1 to E1 did not work.
Also how do I test the Oxygen sensors, again the book covers 6 cyl and
1 wire but not the 2 sensors, 1 at exhaust manifold the 2nd about a
foot below it, both of them have 2 wires.
Thanks Dave
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.