[rama1200]

I just installed an H.I.D. kit on my wife's '01 avln and never noticed how out of aim the head lights were... I basically I took appart the whole light assambly and could not find anything to aim the lights... how do you aim the lights? is there a screw, lever, etc. to adjust?

Also, I tried to replaced the fogs bulbs, but there look a pain to do... take out the little plastic splash gard from under the car, etc.... is there a better way?

Thanks for any input.

 

[ernie01acura]

no need to take whole splash gaurd out, just the few clips and screws at the bottom, enough to hold it back your self, and then get a flashlight so you can see what your doing up there, then you should be able to unplug the harness no prob!!

 

[aznstylez]

I just installed an H.I.D. kit on my wife's '01 avln and never noticed how out of aim the head lights were... I basically I took appart the whole light assambly and could not find anything to aim the lights... how do you aim the lights? is there a screw, lever, etc. to adjust?

Also, I tried to replaced the fogs bulbs, but there look a pain to do... take out the little plastic splash gard from under the car, etc.... is there a better way?

Thanks for any input.

There is a screw in that back of your headlight. It is set in between the high beam and the low beam if I remember correctly. It's an 8mm socket. Turn it counterclockwise to lower, clockwise to lift it up.