[tyler88]

So yesterday i was doin a check on my car and decided it needs the following
- Rotor
-plugs
-plug wires
-dizzy cap
-thermostate
-cable that leds from the O2 sensor to teh ecu
-air filter
- and my coolant needed to be flushed
well i went down to my buddies store whome gives me price at cost and it cost me $33(cad) for an purolator (i thought they delivered packages)air filter(was listed at $48). now is it just me or is this one of the most expensive air filters ive seen? or did something go wrong?

 

[Tercel Lady]

Whhoooaaa!! It is not just you!! I would say around $15, maybe worst a few dollars more than that...if not on sale. I can usually find them at our little discount auto place for around $9 reduced from $15 (though can't swear it's that brand).

Did you use it? Or can you still return it.

Hell, I think you could buy one from the dealer for less than that.

 

[enerjohn]

www.autozone.com

STP part no. SA7167 $10.29USD

FRAM part no. CA7167 $12.19USD

I don't know how much that is canadian.

hell for 8 bucks more you could go cold air.

 

[Tercel Lady]

OOpps. Sorry, I didn't notice that you are in Canada. Don't know what the dollar converts to.

 

[ShowCarTercel]

Is it some sort of performance air filter? Because they are a lot more money because you can just wash then out and use a "Filter Recharger kit" on them to make them new again.

That's why it's good to get a K&N filter that will outlast your car and if it doesn't I do believe they have a lifetime warranty. Saves you money in the long run, plus more power and better gas mileage.

 

[tyler88]

hmm i dont think its a performance air filter but i thought it seem like to much..tomorrow i will phone around more places to check on the air filter so i can return it so i wont install it tomorrow like planned...but i got a set of ngk v power plugs for $15

 

[yaitisme]

enerjohn

looks like you installed your autozone cone the same way I did. Did you find a good way to prevent the cone from bouncing?

scott

 

[enerjohn]

enerjohn

looks like you installed your autozone cone the same way I did. Did you find a good way to prevent the cone from bouncing?

scott

Scott,
I just used the bottom half of the stock airbox.
It just sits in there, but it props it pretty nice.
(sorry the pic above does not reflect this.)

 

[tyler88]

all fixed and got some store credit...it would of been nice if someone told me the plugwires and cap were all one piece instead of me trying (unsuccessfully) to pry them off

 

[enerjohn]

Sorry to hear you were having problems with your install but why try to pry stuff off the cone?
Should of looked here first...

http://www.toyotanation.com/forum/t106477.html

 

[azn_outlaw]

Here is another place and its Canandian....

and they ship....

here you go check them out:

www.oemimport.com