Toyota Nation Forum banner
1 - 1 of 1 Posts

·
02 Spectra Blue Mica
02 Celica GT
Joined
·
284 Posts
This is for the gen 3 not 3.5

If you wait to install till next week I might be able to take mine off to show you. I am about to remount it anyway.

First thing for you to do i he center section of your bumper. This is the easiest peice to do since you are cutting such a big peice out.

Then you move on to the sides. This is where you will need to do some measuring. You want the top of the RMM lip to sit right on top of the line on our bumper. You will need to measure down on the inside lip of the RMM lip to the vents. Take that measurement and subtract a little from it. The measure down from the line and draw a line. Next you measure the vent size and placement and make marks. From here you will have a rough dimension on what you need to cut out. The catch here that the RMM instructions don't show you is that the vents can hit your lowersplash guards and all. I had to cut fromthe top all the way down and remove any part of the bumper that was there.

I would recommend Taking your stock bumper off to do the cutting. The reason is that you will see where the new RMM hits from the inside and can make the minor cut adjustments easier.

As for the mounting. Do you have a flexible adhesive? ie: flexbond or something like it? I originally didn't use the correct stuff so I will be remounting mine. I would look at either using this along with the screws in the wheel wells or using pop rivets to make sure it stays in place.

Any more ?s let me know... Hope this helps
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top