Toyota Nation Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
206 Posts
Discussion Starter · #1 ·
I recently had a remote start (viper) installed on mt 2012 SE. I noticed that after the install that my bluetooth is not working correctly. I can hear people talking but they can't hear me. I would like to know where the microphone is located so I can look at it for myself. Then, I am going back to the installer and crawl someones ass. Thanks in advance.
 

· It's Official
16 Tundra, 14 RAV4,
Joined
·
8,905 Posts
oh man that sucks...i hate when people cant seem to do their job at the expense of my car.

The bluetooth mic is in the upper console in the headliner where the lights and sunglasses case/sunroof controls are. you will see a little spot that looks like it has little grate going over it. Thats the mic in there.
 

· Registered
Joined
·
206 Posts
Discussion Starter · #3 ·
Thanks GA.

It turns out this was my fault. I dropped the console to hardwire my radar detector today. I noticed this after I hooked it back up. I took some pictures so I could post a better DIY than what is listed on this site.

The alarm installers still suck. They left screws out of my dash, the alarm won't even start my car, and panels were left unsnapped in place. They are getting ONE chance to fix it before I tell them to yank the Viper out and refund my money.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top