Toyota Nation Forum banner

brake disc rotor loose

5304 Views 2 Replies 3 Participants Last post by  bbsgarage
hello everybody cool site,well the question i have is i have a corolla 1.4 04....i seem to be hearing clicking sounds coming from my wheels alot it seems to change wheels i think it coming from two wheels so i decided to take the wheels off to see what it was everything looked ok no stones or anything in the wheels.but then i happened to just move the rotor/brake disc and it seems a bit loose it moves back and forward a bit should it be like the other wheel is not like that and if it not supposed to be like that how would i tightening it.the wheel seems to grind abit when i spin the wheel jacked up only on half the disc so it grinds half way around the disc and than the other half is fine no grind any ideas what that would be.........
1 - 3 of 3 Posts
Everything sounds normal.

The clicking is normal on the brakes. It's just the pads shifting a bit. I've heard it on every Corolla I've driven. The rotors are held tight by the lug nugs when you tighten them, one of the rotors may have rusted tight.
..... when i spin the wheel jacked up only on half the disc so it grinds half way around the disc and than the other half is fine no grind any ideas what that would be.........

the rotor is warped, usually having them ground will cure this. or depending on how many miles are on them, just replace the rotors with your next brake change.

the clicking would be the pads shifting in place and is more of an annoyance then a problem.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top