Toyota Nation Forum banner
1 - 1 of 1 Posts

·
Moving Forward
Joined
·
3,144 Posts
are you putting it in any kind of vice or something simialr. IT will make it a lot easier.
use a good sized hammer nad a brass punch if you can. the brass will deform and not cause damage to the joint, unless you jsut dont care about the old one. There is a snap ring that holds it on to the axle shaft. Sometimes you ahve to hit it pretty hard ofr it to come off. IF you use a punch of some sort you can hit it right up against where the shaft goes into the joint assembly. SOmetimes you will get a slight amount of movement from teh joint on the shaft since the only thing holding it on is the snap ring.

The vice is key though. You need to make sure the axle doesnt move when you are hitting it witht he hammer.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top