Toyota Nation Forum banner

Cutting stock springs.. (flame suit on)

20K views 19 replies 13 participants last post by  Jaspher 
#1 ·
I have been thinking that maybe my best way to achive the small lowering im looking for around 3/4"- 1" would be to cut some OEM springs to achive this im not talking alot here i would think 1/2 a coil would be plenty to do this?

-whats it do to the ride hows it effect the spring rates?

Opinions and comments......... just say it i really don't care i just want some other points of view to help me make a decision...
 
Discussion starter · #8 ·
i have the eibach prokit, and there the problem, i should be able to cut only 1/2 or 3/4 because the tops front and back are closed and ground (sit flat)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top