Toyota Nation Forum banner
1 - 1 of 1 Posts

Sequoia 2004 Limited
1 Posts
Discussion Starter · #1 ·
I drive a Toyota Sequoia 2004. The airbag light started blinking a few days back.

Sometimes, I can switch the engine off, adjust the seat, and the light comes off (i.e, the airbag system is now engaged). Often, the light will again start blinking and keep blinking.

So I took it to the dealer for a diagnostic. They showed a P0116 Driver's seat airbag malfunction NOTES SHOW:
- open in circuit. inspected #2 floor wiring harness -OK
- inspected airbag sensor assembly module - not malfunctioning at this time.
- inspected airbag assembly - no open circuit found.

Reset air bag light - no codes found at this time.
If light reappears, need back assembly $2599 (NEW DRIVER"S SEAT!).:confused:

The light is blinking again, and replacing the entire driver's seat seems very pricey to me. The re-setting of light to me indicated some lose wires, but the dealer's service dept. doesn't see it that way.

Has anyone else with a Sequoia or a Tacoma faced this issue?
Any advice?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.