[The ham]

I recently had my check engine light show itself on my 2002 camry 3.0L v6. I went out to have the code checked, turned out to be code PO446, and I've had it sorted out by now. The only issue that I now face is that, since the guy used the code reader to check what was wrong, my vehicle stability control and traction control light are on after I shift into drive. Neither one will turn off regardless of how far I drive, even after I press the traction control button, nothing happens to that light.

Anyone know what I can try out to fix this?

 

[mcgowaw]

just the act of putting a code reader on it shouldn't cause problems. might start looking for any wires that are unplugged. also it seems a bad gas cap can cause these 2 lights to come on just doing a google search.
tony

 

[Camry_wiz]

Try pulling the battery and allowing the ECU to reset. If the lights come back on, then you have a serious problem.

 

[dtownfb]

The ham: read through this thread on VSC and trac lights on. Although it's a 2008 Camry, it may apply to your 2002. Basically, the issue that triggered the check engine light may have shut off the VSC and TC.

http://www.camryforums.com/forum/general-tech-8/vsc-traction-control-check-engine-lights-all-5015/

Hopefully this helps. Good luck.