Toyota Nation Forum banner

headers for gen 2 V6?

985 Views 10 Replies 5 Participants Last post by  toyrolla
Does anyone make headers for the gen2 V6?
1 - 4 of 4 Posts

· Mad Scientist-In-Training
Joined
·
922 Posts
I'm current doing some R&D on my Gen2 V6 for the following:

Cold Air Intake
Turbo Manifold design

Right now, I'm a little short on time because of other things going on, but I hope to at least have the CAI done in a few weeks.

Drop me a PM and I'll keep you posted.

Till then, stay tuned. ;)
 

· Mad Scientist-In-Training
Joined
·
922 Posts
white90dx said:
The packaging is all wrong for a good header on the gen2 Camry V6... If you really want power, you'll have to attach a turbo back where the two manifolds meet behind the engine. ;)

-Charlie
Y-Pipe, exactly...;)
 

· Mad Scientist-In-Training
Joined
·
922 Posts
epborden said:
Or buy the 5SFE Rippmods header kit, bolts right on

$469.95 I think :)

I am going to, well, when the bitch runs :thumbup:

The Rippmods 5SFE header kit will not bolt on to the 2VZ-FE V6 engine.

However, it can be used to bolt on to the 3SFE.

$469.95???
For a header???

Ummmmmm, No....

I live close enough to Ripp to pick it up locally from them....and the answer would still be No....:lol:

I paid about that ballpark figure for my newly acquired (and very very mint) 89 4cyl 5-speed..:D
 

· Mad Scientist-In-Training
Joined
·
922 Posts
epborden said:
Haha sorry to scare you

It includes everything you need, including high flow cat

It is a really nice system

but sorry no V6 =( I don't think

Define "everything"....

Is it a full exhaust system from the header to the tailpipe?

:D
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top