[tom42nm]

I am pulling the transaxle to replace the ring gear (and possibly clutch) on the flywheel.

88 Camry 3sfe 5 sp fwd.

Putting the jack stands under the frame rail.
How high should I be for easy trans removal?

OR should I use floor jack under engine crossmember and put them under the pinch rail?

Tom

 

[white90dx]

Go with jack stands on the pinch rails. You will need to remove the front sway bar mounts, which are otherwise a good spot to put jack stands at the front of the car.

As for height... it doesn't have to be too high. You can drop the trans onto a couple layers of cardboard and slide it out. It isn't very heavy... (try that with the V6 manual... MUCH heavier )

-Charlie