Toyota Nation Forum banner

Help! How to remove a bolt for replacing passenger mirror

1031 Views 2 Replies 2 Participants Last post by  JSM1284
Hi! I am trying to replacing the passenger mirror for my Camry LE 2003. I am finding I have troubles removing the old broken mirror. The problem is that I cannot unsrew the third bolt after taking off the other two. There has so little room for my 10mm wrench, so I am wondering if anyone can help me which tool I need to use or which part I need to take off first. Thanks a lot for your help!:sosad:
1 - 3 of 3 Posts
4
Take off the door panel.

OVERHAUL

HINT:

  • Installation is in the reverse order of the removal. But the installation is indicated only when it has a point.
  • In the RH side, work in the same procedure as in the LH side.


  1. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSY
    1. Remove the front door armrest base cover lower.
    2. Remove the screw.
    3. Using a screwdriver, remove the power window regulator master switch assembly then disconnect the connector.
HINT:</B> Tape the screwdriver tip before use.


  1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
    1. Using a screwdriver, remove the front door lower frame bracket garnish.
HINT:</B> Tape the screwdriver tip before use.


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
    1. Using a screwdriver, remove the front door inside handle bezel plug.
HINT:</B> Tape the screwdriver tip before use.


  1. REMOVE FRONT DOOR TRIM BOARD SUB-ASSY LH
    1. Remove the hole plug.
    2. Remove the 5 screws.
    3. Remove the clip.
    4. Using a screwdriver, remove the front door trim board.
HINT:</B> Tape the screwdriver tip before use.
    1. Remove the inside handle then disconnect the 2 cables from the front door lock assembly.
See less See more
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top