Toyota Nation Forum banner

How to test and replace Torque Converter

1K views 3 replies 0 participants last post by  L 
G
#1 ·
After replacing the timing belt and water pump, my 4runner runs fine on idle,
but when put in gear, it sputters and crawls and stalled. From when I read
in the forum, most lightly is the torque converter. Does anybody know how
to test the torque converter? Any diagram on where is the location and how
to install it?

Thanks,
-don

--
Message posted via http://www.carkb.com
 
G
#3 ·
If the truck ran well before the timing belt was replaced, my guess is that
your problem is related tothat service, not the torque converter.

While is possible that the torque converter is the problem, the more common
failure of the TC is to slip, not lock to point of stalling the engine.



"Coolguy via CarKB.com" <u17209@uwe> wrote in message
news:5a25872c109f8@uwe...
> After replacing the timing belt and water pump, my 4runner runs fine on
> idle,
> but when put in gear, it sputters and crawls and stalled. From when I
> read
> in the forum, most lightly is the torque converter. Does anybody know
> how
> to test the torque converter? Any diagram on where is the location and
> how
> to install it?
>
> Thanks,
> -don
>
> --
> Message posted via http://www.carkb.com
 
G
#4 ·
I must agree here ... sounds like the timing belt is a few teeth out
.... sounds hard to beleive that it would damage the TC when doing
waterpump/timing belt.

If the TC is letting go then the truck would liekly rev up fine but
not go anywhere

Matt
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top