Toyota Nation Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1 (Edited)
Update: We've discoverd this is the knock sensor wire. We had to remove the intake manifold again to find that we'd failed to connect the sensor when we first assembled the manifold.

My son and I are reassembling his 3L after getting a valve job. While connecting the injector wiring harness we noticed a 2-pring female connector sticking out from the driver side of the harness. We can't find what this connector is meant to be connected to. We've looked through the Haynes manual but it was not help. We've also searched this forum, again no help. Any ideas?
 
1 - 1 of 1 Posts
Top