Toyota Nation Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1 (Edited)
Sorry for my first post being so needy... but I am getting desperate. I am trying to program a new key fob (after market unit from iKeyless) and I am tyring to hit the reset button on the ECU of my 2002 Tundra. After much looking I found the ECU (in a nearly impossible location. But I can not seem to get any kind of button depressed, no matter how hard I push on the recessed green dot. Does anyone have any suggestions as to how to accomplish this feat?

Here are a couple of photos of what I think is my ECU





I have tried a small jewelers screw driver (which is pretty stiff and fits in the hole) but to no avail.

Ideas?
 
1 - 2 of 2 Posts
About this Discussion
1 Reply
2 Participants
burned300
Toyota Nation Forum
ToyotaNation Forum is a community dedicated to all Toyota models. Come discuss the Camry, Tacoma, Highlander, 4Runner, Rav4 and more!
Full Forum Listing
Top