Toyota Nation Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
136 Posts
Discussion Starter · #1 ·
I had the pen looking apexi timer with A/F display, however, it never works out for me. Because i have A/F ratio sensor in the front and that gave different voltage. Then i tape onto the 2nd bank O2 sensor, yeah it works but not accurate. Then i installed a universal single wire O2 sensor on the down pipe, but my A/F just keep flash without any number. (voltage goes up from 1.xx to 0.02). Is there suppose a setting for the timer or something?

thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top