Joined
·
1 Posts
Hi there;
I am currently working on a small project, installing this engine into a Dune buggy. I was told that only four wires are required to start the enging. Can't figure which ones.
The engine came with 2 attached from the harness to the ECU, the other 2 don't fit into the ECU. Can somebody tell me where these extra attachments go? Maybe I don't ned them after all to start the engine.
Basically, my problem is not getting a spark. the engine cranks though. We checked the fuses and the wires. All are good.
We are puzzled
This is a JDM 3S-GTE engine, bought complete with ecu (allTrac 93 TwinCam turbo Celica)
Thanks
I am currently working on a small project, installing this engine into a Dune buggy. I was told that only four wires are required to start the enging. Can't figure which ones.
The engine came with 2 attached from the harness to the ECU, the other 2 don't fit into the ECU. Can somebody tell me where these extra attachments go? Maybe I don't ned them after all to start the engine.
Basically, my problem is not getting a spark. the engine cranks though. We checked the fuses and the wires. All are good.
We are puzzled
This is a JDM 3S-GTE engine, bought complete with ecu (allTrac 93 TwinCam turbo Celica)
Thanks
