Toyota Nation Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
During my lunch hour, I decided to check the PCV valve on my 1MZ-FE to see if it was clogged. Sure enough, the rattle test proved my suspicions and I bought a replacement PCV valve and grommet.

Trying to use needle nose pliers to pull it out, one side slipped in and the entirety fell down into the valve cover. Arrrgh.

I did my best to feel inside using a dental pick and find it, but it seems to be lost.

Is the grommet going to be caught by a guard plate of some sort? Would waiting until the weekend to remove the valve cover and other in-the-way assemblies be a bad idea?

Any advice would be appreciated, kind of worried here.
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #3 ·
Thank you! That eases my mind a little bit.
 
1 - 2 of 2 Posts
Top