Toyota Nation Forum banner
1 - 2 of 2 Posts

1 Posts
Discussion Starter · #1 ·
We bought PowerFC
for 3S-GTE (SW20). But the engine we've is 3S-GTE from Toyota Caldina GT-T
(ST215W). So we've some problems, hope you can help:

1. We need ECU wiring diagramm for SW20
2. What signal used by PowerFC (SW20): AirFlow meter or MAP sensor, or both.
3. What type of ignition control used by PowerFC (SW20)? Because
Caldina engine has one coil per one sparkplug, and doen't have any
distributor, so ingnition controlled directly from ECU.
4. What diffrent between PowerFC boost up kit for SW20 and other?

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.