Toyota Nation Forum banner

Pulling up rear seats

1598 Views 6 Replies 5 Participants Last post by  GT-R
hey guys!
I'm trying to install seat covers on my camry 2011, I managed to install them on the drivers and passengers seat and it was fairly easy. But now I'm stuck on the rear seats, I did the back seat, but I'm having problems installing them on the bench/bottom seats. Is there any way to lift them up a little at least, so I can install the seat cover.
1 - 7 of 7 Posts
If the rear bench follows the same design as in my '04 Camry then it is held in place by two plastic clips located about 1 foot from each end of the bench. The way I take them out is to grab fairly close to these clips on the underside of the rear bench and pull up and slightly forward towards the front of the car. The design in your '11 may be different so I would probably wait for someone else to give a confirmation.
Been covered before on GEN6....SEARCH.
If the rear bench follows the same design as in my '04 Camry then it is held in place by two plastic clips located about 1 foot from each end of the bench. The way I take them out is to grab fairly close to these clips on the underside of the rear bench and pull up and slightly forward towards the front of the car. The design in your '11 may be different so I would probably wait for someone else to give a confirmation.
thanks a lot, I'll wait for someone to confirm it for me.

Been covered before on GEN6....SEARCH.
tried that already found one thread on a hybrid and others for older models.




help would be appreciated guys.
:headbang::headbang:
I did some searching myself and your car should have the same seat removal procedure. A hybrid Camry is no different from a regular Camry, just the power source is different.
The bottom part? Just lift it with a little force to unhook the 2 clips (one on each side).
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top