Toyota Nation Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
ok i have a couple of issues. it's a 4cyl 96.

the CEL is on. i got my haynes and followed the directions to jump the terminals, but all i get is a solid light...it doesn't ever blink anything. this of course is me trying to do it by myself, id push the paperclip in and run over to look, but i'm pretty sure it wouldn't go that fast right?

i took it to autozone to have them read it and they said they can't because it's a different connection than what they have?? is my autozone on crack or what? i couldn't ever find the port under the dash either, i just found the one under the hood (haynes says there's 2)
 

·
_trancemaster_
Joined
·
399 Posts
My cam is 96 as well, and autozone read the codes fine for me...
Port should be behind that little compartment on your low left side by the steering wheel... pop that thing off and it should be there...
Try different location maybe?
I don't know what they smoking there, but it works =)
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #3 ·
ok cool. i'll go back tomorrow and show them that one. i hate my autozone, the people there are idiots!
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #4 ·
ok, they pulled a p0420. i know that means cat/o2 sensors or something like that. where should i start to tackle this?
 
1 - 4 of 4 Posts
Top