Toyota Nation Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Bought my 4runner a little over a year ago and the dealer put the license on with the wrong sized screws, so the screw was barely seated in the threads. I went to Home Depot and bought what I thought were the right size after reading something online and it turns out they were also too big. So this whole time I've had my license plate flapping around in the wind on two screws that barely fit in the threads.

So...what's the right size for these damn things?
 

·
Registered
Joined
·
80 Posts
Screw Size

I purchased Stainless ones for my 16 highander and 17 Rav4. They were both Metric Truss Head Machine Screws 6MM x20MM. You might try that size.
 

·
Registered
11 Toyota Highlander
Joined
·
18 Posts
Thanks so much for the screw size information. It fit perfectly and now the plate and the frame are solid against the vehicle! I also changed the screws on my highlander as it has the same size requirements. 2011. :thanks::
 
1 - 3 of 3 Posts
Top