Toyota Nation Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
when you remove the valve covers make sure to grind the spacers that the mounting bolts go threw. the plastic valve covers "shrink" over time but the metal spacers dont. this will cause the valve cover gaskets to leak no matter how many times you replace the seals. just grind them flush with the cover, with a die grinder, with a flat pad. torque the mounting bolts to 95 inch pounds or hand tight, there only 10 mm bolts.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top