S13 Front Splitter on AE86

2282 Views 9 Replies 8 Participants Last post by Flashmn, Aug 9, 2004

driiift_hachiroku

Discussion Starter · Aug 9, 2004

I went to the Scrap Yard (Cookstown Auto Parts), and found no Corolla GTS's...heck not even 1 RWD Toyota! (No, not even MR2's).

So I ended up looking for anything for my 240SX. I found a front splitter from the higher model SE 240SX (early model, pig nose). I thougth how great it was that the 240sx can finally get it's first "mod".

After going home, I tried the front splitter on the 240sx. Great, it looks like it won't take much to install. Then after already putting the splitter away, I took it back out to try it on the Corolla...

check it out:

I haven't attached it on yet, but I think it'll work. Anybody else try this?

Jover

See less See more

Save

1 - 10 of 10 Posts

90rolla_4

· #2 · Aug 9, 2004

I like it

Save

Twincam16

· #3 · Aug 9, 2004

I used the one from an earlier model CRX but with a little bit of "cutting and pasting". That one looks like an exact fit.

I like it!!! :thumbup: :thumbup:

Save

Deep

· #4 · Aug 9, 2004

Looks a little odd, maybe because its quite a bit lower at the front than near the fenders. Could you make it parallel to the ground?

Save

driiift_hachiroku

Discussion Starter · #5 · Aug 9, 2004

Looks a little odd, maybe because its quite a bit lower at the front than near the fenders. Could you make it parallel to the ground?

It isn't even sitting right on the bottom of the bumper cover. It was just kinda placed there by carefully hooking on only the ends.

it's pretty cool how low it makes the front though.

Save

Deep

· #6 · Aug 9, 2004

Yeah, it looks like your plate is keeping it from sitting right, if it was though, it would look nice and clean.

Save

sleepy

· #7 · Aug 9, 2004

i found a lower lip from a 200SX, and i've gotten mixed reviews about it. it doesn't quite fit, but yet some actually like it, so i left it there...mainly b/c i'm too lazy to take it off again :lol: the sideskirts are in 4Aaron's hands now

i found a few i'd like to try as well, it just doesn't seem complete in the front of the 92 coupe, esp. with my 4x4 susp, lol

See less See more

Save

project trueno

· #8 · Aug 9, 2004

very aggressive front end jover! Did the lip happen to be red as well? How convenient

chester: leave the lip on, the "triangle" ends on each side matches the oem AE92 skirts

:thumbup:

Save

hopeful

· #9 · Aug 9, 2004

lol, yeah jp from DK has done that actually... I want one too, super pimp

Save

Flashmn

· #10 · Aug 9, 2004

MAybe its just me, but I'd think Id try to blend it more to the bumper.

Save

1 - 10 of 10 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month