Toyota Nation Forum banner
1 - 14 of 14 Posts

· Registered
41 Posts
Discussion Starter · #1 ·
I found out that Addco is looking for a 98-01 ES300/Camry to test out front and rear sway bars on. They'll need to borrow the car for about a day or so, but when the finished product is ready you get a free set. I'd do it myself, but they're located on the other side of the country from me. If anybody is around the NorthWest part of North Carolina or Southern Tennessee (or willing to make that drive) then please contact the nice folks at Addco or you can just pm me and I'll set you up with them.

Contact Info:

1596 Linville Falls Hwy
Linville Falls, North Carolina

Ask for Dan Osborne, and tell him Carlos from Performance Center sent you.
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.