Toyota Nation Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
544 Posts
Discussion Starter #1
Changed the spark plugs on a V6 and inadvertently pulled two of the wires out of the connector for the aft bank Cam Position sensor. That last coil pack is a bear. Can anybody confirm the wire positions are the same for the front bank sensor connector and looking for info on reinserting the wires. One came out with the orange boot the other is just a bare wire on the end.

It's an 07 ES350, with a 3.5 L 2GR-FE V6 just a Camry with a nice suit on.

Thanks in advance
 

·
Registered
Joined
·
544 Posts
Discussion Starter #3
Perfect. The red was still attached so with the black in the middle even I could figure the rest out. A replacement connector with wires attached, a little soldering and its done.

Thanks
 

·
Registered
Joined
·
320 Posts
This is the reason I love forums such as this one. Any given individual could drive themselves crazy trying to find a specific piece of information with which they're unfamiliar or for which they don't have the correct documentation. Others, generally who've "been there, done that," have it at their mental fingertips and can pull up their electronic copy for sharing at a moment's notice.

It's a lovely process to observe (and participate in, too).
 
1 - 4 of 4 Posts
Top