The bottom seat cushion is held on by 2 clips that are located at the front of the cushion. All you need to do is pull up on the cushion and it should come right out.

 

Arisotezza18 is correct, I just took mine out about a week ago. If you give it a good, even tug, the seat will pop out. Find where they are located and move your fingers over about 4" and pull up towards the ceiling.

Note: Noted above refers to my 93. The photo below is one I found on this forum and I believe it is a 3rd gen Camry

 

My rear seat was out today for some interior refurbishment work and the 3rd generation rear seat bottom
is secured with THREE clips into the sockets, not two. But in any event, all you do is pull the front edge of
the seat straight up with moderate force and it pops right out.


CJ

 

Strange, I think mine was 2 also in the XLE. Regardless...same procedure.

 

kk ty all very much!