Hi everyone, i am new to this site and need help with my 2010 toyota venza
so here is whats happening. I have a 2010 toyota venza with the factory back up camera that is displayed on the multi information display when put in reverse. I have bought a new aftermarket backup camera that i have wired in and will be getting an aftermarket navigation system. So the camera will be displayed in the aftermarket display instead of the multi information display. The problem i am experiencing is that the multi information display is still going into reverse camera mode. Even though i have disconnected the factory backup camera. I have read that there is a reverse trigger wire behind the multi information display and that cutting it would prevent the information display from going into reverse mode. I am unable to locate the reverse trigger wire. I have looked everywhere for color codes and videos. And have found nothing. Please help! Thanks.
so here is whats happening. I have a 2010 toyota venza with the factory back up camera that is displayed on the multi information display when put in reverse. I have bought a new aftermarket backup camera that i have wired in and will be getting an aftermarket navigation system. So the camera will be displayed in the aftermarket display instead of the multi information display. The problem i am experiencing is that the multi information display is still going into reverse camera mode. Even though i have disconnected the factory backup camera. I have read that there is a reverse trigger wire behind the multi information display and that cutting it would prevent the information display from going into reverse mode. I am unable to locate the reverse trigger wire. I have looked everywhere for color codes and videos. And have found nothing. Please help! Thanks.