I am planning a big overhaul of front and rear suspension parts. Will replace all four with strut assemblies and all 4 end links. I have got a pretty good idea on steps. But I am not sure about torque specs. Any one can help? Thanks in advance.
For end links.
1. My impression is that the rear ones are 29 ft lbs. But I saw Kingdom put a 47 ft lbs on a TRD bar. I am going to use a Whiteline bar, does it mean that I also need 47 for the rear?
2. The busing bracket bolts should be 14 ft bls.
For front struts.
1. I remember the three nuts on top should be 60 ft lbs.
2. How about the two big ones at the bottom?
For rear struts
No idea here at all. Cannot find any DIY guide on torque spec.
For end links.
1. My impression is that the rear ones are 29 ft lbs. But I saw Kingdom put a 47 ft lbs on a TRD bar. I am going to use a Whiteline bar, does it mean that I also need 47 for the rear?
2. The busing bracket bolts should be 14 ft bls.
For front struts.
1. I remember the three nuts on top should be 60 ft lbs.
2. How about the two big ones at the bottom?
For rear struts
No idea here at all. Cannot find any DIY guide on torque spec.
