Toyota Forum banner

Blind spot monitor sensor connector wiring

1 reading
1.4K views 3 replies 2 participants last post by  ukrkoz  
#1 ·
Hello, I just purchased 4 gen (2017) prius with a crashed right side bms sensor wire connector. I ordered a new connector, and I just thought I can pin it in the same order as on the left side, but I realized the wire colors are different there. I spent good half hour digging through different diagrams, but I couldn't find the right one anywhere. I did my best to connect it by color and wire thickness, but I'm not sure this is the right way. Maybe someone has a wire diagram for bsm sensor with wire colors, or maybe someone has an easy access to the right bsm sensor to take a picture how the wires are wired there. Any help would be appreciated!
 

Attachments

#3 ·
When I got the car, there was no connector at all, only loose pins. I assume they disconnected the harness, and then backed up and ran over it, so it was completely crashed.
I think my best shot is to find someone with the same prius who has a rear bumper taken off, in that case it's pretty easy to disconnect the harness and take a picture of the wires, where which one goes.