You nailed it, that's all there is to them. Removal of the bumpers is the easiest route and you can see all the clips holding them in and it will make removal and install a lot easier.

 

Do you happen to have a guide I can use as reference? Finally found some time I can set aside to doing this.

 

probably be easier to remove the whole bumper from the car and then take it off so you have access to the back part.

front bumper DIY, its fairly easy i done it a bunch of times to change out my headlights, i can remove the bumper in 10 mins now.

http://www.toyotanation.com/forum/showthread.php?t=234677

The rear bumper is the same concept, i can't find the diy on it though. The bolt behind the rear splash guard is pain when i did it.

 

what's the easiest way to get a kit piece off the bumper & side of the car? i've considered using a heat gun, but it may damage the paint. and i'm not convinced Goo Gone alone will cut it.

 

Side skirts are held on with 10mm nuts with a phillips head. As for the front part of the kit, it is clipped in with tabs and held together with a double sided type tape made more to look like a gasket.

 

how do i TAKE IT OFF?

 

PM me your email address and I will provide answers...