Hello Everyone,
Vehicle:
1997 Toyota Corolla DX 1.8L
4 Cylinder
I'm new to the forums here, recently I've been trying to get my 1997 Toyota Corolla Dx 1.8L on the road but before doing so I'm trying to get it to start. It had a CEL code popping up in the instrument area and I ran the code to find out it was a defective Crankshaft Position Sensor or PO335 obd ii code.
My issue being that I know the general areas of where it is located but am new to Toyota vehicles and I'm trying to locate both ends of the Sensor. Would anyone happen to have pictures, a video or any information available such as a diy tut as to how the process goes so I have a little guideline to follow? Any and every bit of information is greatly appreciated and thank you all in advance.
Best regards,
SJohnson138
Vehicle:
1997 Toyota Corolla DX 1.8L
4 Cylinder
I'm new to the forums here, recently I've been trying to get my 1997 Toyota Corolla Dx 1.8L on the road but before doing so I'm trying to get it to start. It had a CEL code popping up in the instrument area and I ran the code to find out it was a defective Crankshaft Position Sensor or PO335 obd ii code.
My issue being that I know the general areas of where it is located but am new to Toyota vehicles and I'm trying to locate both ends of the Sensor. Would anyone happen to have pictures, a video or any information available such as a diy tut as to how the process goes so I have a little guideline to follow? Any and every bit of information is greatly appreciated and thank you all in advance.
Best regards,
SJohnson138